WaterSam® special sampler WS 16
with fully automatic injection of preservatives e.g.
H2SO4,  H3PO4,  CuSO4  and  HCL

more

Loading station for chemical products
with automatic sampling

more

The channels of
the capital of Korea are situated in a depth of up to 20 metres.
WaterSam samplers with fully automatic fresh water rinsing system and the
WaterSam VacuPress-Sonde for high lift
heights draw the samples from these depths

more

After an initial consignment of 20 samplers in the year 2000 further 50 units have been ordered in 2003.
These especially developped samplers for highly contaminated tannery waste water are installed in a main zone of leather industry
between Florence and Pisa in Italy.
The sampler is controlled by a 
magnetic-inductive flowmeter.
A datalogger registrates the required data.
They can be downloaded remotely via data line or GSM modem.

more

WaterSam projects and provides
complete solutions for sampling and
monitoring at large sewage treatment plants.
The picture above shows the central
sampling roomof the sewage treatment
plant Nuremberg I.
Here samples are taken out of all the waste water streams of the treatment plant.
At the same time several parameters like
pH, conductivity, Redox, dissolved oxygen, temperature and turbidity
are continously measured.

more

Decision for WaterSam.
Over a period of one and a half years 63 samplers have been delivered to Belgium.
After a testing phase of 6 weeks the decision of a large Belgian waste water discharge company
was taken in favour of WaterSam.
The samplers were tested at inflows of treatment plants with suction heights of 6-8 metres.
Special requirements were to be realised according to the tender.
WaterSam received the order due to its cost-performance ratio and the very good technical conception.

more

WaterSam GmbH, Felix-Wankel-Strasse 70  , D-72108 Rottenburg
Tel.: +49 (0)7472 9882-0   Fax: +49 (0)7472 9882-22

Copyright WaterSam GmbH

last updated:

Webmaster Klaus Majowski